The file was acquired by the United States Holocaust Memorial Museum in 1990.
Heavy, gray-colored, metal file consisting of a long, rectangular bar with a rounded surface, flat sides, and tapered ends. The top and bottom surfaces are wavy and rough-textured, but worn down from use. On one end, the bar curves upward about 45-degrees, and both ends are flat and narrow. The surface is heavily corroded throughout.
No restrictions on access
No restrictions on use
overall: Height: 10.500 inches (26.67 cm) | Width: 1.000 inches (2.54 cm) | Depth: 0.375 inches (0.953 cm)
Flat file, possibly for a shoemaker, similar to those used by Jewish forced laborers in the Łódź Ghetto in German-occupied Poland from May 1940 to summer 1944. Łódź was occupied by Germany a week after the September 1939 invasion of Poland. It was renamed Litzmannstadt and in February 1940, the Jewish population of about 160,000 people was confined to a small, sealed-off ghetto. All residents had to work, and 85 percent of the ghetto population labored in nearly 100 factories. The major ones produced textiles, including uniforms for the German Army. Occupying authorities seized much of the specialized machinery from the Jewish population, forcing them to use hand techniques for production. Due to severe overcrowding and scarce food, disease and starvation were common. The Judenrat (Jewish Council) administered the ghetto for the Germans, and chairman Mordechai Rumkowski thought hard work and high output would preserve the ghetto. However, in January 1942, mass deportations to Chelmno killing center began; half the residents were murdered by the end of the year. In summer 1944, Łódź, the last ghetto in Poland, was destroyed and the remaining Jews were sent to Chelmno and Auschwitz-Birkenau killing centers.
Flat file of the type used in Łódź Ghetto